Page 1 of 2
Armor Damage Absorption
Posted: Mon Apr 25, 2016 5:28 pm
by
Is the rate at which armor deteriorates based on damage absorbed, or the number of blows taken? Would anyone care to enlighten me, if they have the statistics?
Additionally, has there been any information on armor materials as to how much they detract from a damaging blow? Is it percentile-based, a flat number, or both?
-Kschilan's Player
Re: Armor Damage Absorption
Posted: Mon Apr 25, 2016 11:26 pm
by
Right, this reminds me also... Does armor size has something to do with this as well? Like, is it going to detoriate faster if it's not your size? This could be just my feeling, but somehow this is the idea i got...
Re: Armor Damage Absorption
Posted: Tue Apr 26, 2016 1:51 am
by
Armor has "uses" too. So it can only be hit so many times, until the uses are all gone and you have to repair it. The same system goes for shields and weapons.
I believe it's mostly % based with a very low flat # attached. I only say that, because I can wear my best armor in a level 1 area and still take damage. But sometimes, the hit from the same MOB will be so low, that I will take 0. However, I do know that materials matter greatly in the % that's blocked. Persarium is the best metal, though they have never sold a chest piece, followed by Arcsilver and then Blacksteel.
Edit: To answer the second post: No, size does not matter.
Edit2: I went through to try to find the post that gave the list of materials and finally found it. So if it hasn't changed, the following is still correct:
**EDITED OUT INFORMATION~Pahzrael**
Sorry, but the old list I had posted is no longer valid and should be posted as any sort of official information at this time. Sorry about any confusion. We will try and have something more official by our September Launch date
********************************
Re: Armor Damage Absorption
Posted: Tue Apr 26, 2016 6:29 am
by
Bocon L wrote:Bows
*Note, weapons dropped by MOBs will NOT follow this progression, only store bought/peddle ones.
**edit out information--Pahzrael**
Two corrections:
Teak is exceptional to Osage/Yew
Redwood is lesser to Ebony
So the Bows list is as follows:
Bone/Wood
Birch/Bamboo/Poplar
Hickory/Maple/Willow
Elm/Fir
Oak/Cedar/Walnut
Osage/Yew
Teak (Custom)
Redwood (Custom)
Ebony (Custom)
Silverwood (Custom)
I have held each of these of these bows minus Silverwood.
Re: Armor Damage Absorption
Posted: Tue Apr 26, 2016 11:57 am
by
Kody, this list came from staff near the end of last year. Did they tell you that? Or are those assumptions based on something?
Edit: I don't think that using bows is going to tell you much when trying to come up with your own list, since the damage tables are super sporadic right now, I doubt anyone could correctly discern the best materials in a correct manner.
Re: Armor Damage Absorption
Posted: Tue Apr 26, 2016 12:28 pm
by
as far as bows, all we have to go from is AR and testing. We do need to be careful with the custom ones as one custom bow may or may not have the same AR as another of the same material. But so far it does seem consistant. I am looking forward to perhaps seeing a mahogany bow.
Values of the wood will not match this list exactly unless there is a fluke with redwood values. But this is drifting from the OP.

Re: Armor Damage Absorption
Posted: Tue Apr 26, 2016 2:19 pm
by
The problem is that no matter what the bow is, the damage with a near max bow is going to be anywhere from 2 to 35+(crit) damage. This was tested extensively in the arena with 0 armor. I think it would be incredibly hard and maybe even impossible to actually find out material differences by just hunting. Especially since you cannot see the damage numbers.
Re: Armor Damage Absorption
Posted: Tue Apr 26, 2016 4:24 pm
by
Did this compare with a lower quality bow having a different or same range (higher median damage shots with the max bow compared to a lower median damage range with the lesser bow)? Or are you talking about all the near max bows being pretty much the same? If my AR is higher, I am going to expect a bit more damage over time than with a lower AR.
Would be interesting to run several trials with a wide selection of bows.

Re: Armor Damage Absorption
Posted: Tue Apr 26, 2016 5:56 pm
by
Bocon L wrote:Armor has "uses" too. So it can only be hit so many times, until the uses are all gone and you have to repair it. The same system goes for shields and weapons.
I believe it's mostly % based with a very low flat # attached. I only say that, because I can wear my best armor in a level 1 area and still take damage. But sometimes, the hit from the same MOB will be so low, that I will take 0. However, I do know that materials matter greatly in the % that's blocked. Persarium is the best metal, though they have never sold a chest piece, followed by Arcsilver and then Blacksteel.
Thank you for the information Bocon. I suspect that once the combat system has been corrected to the desired ranges, we might be able to verify (or at least narrow down) the numbers with each material through thorough testing.
-Kschilan's player
Re: Armor Damage Absorption
Posted: Tue Apr 26, 2016 7:32 pm
by
I'm talking about both. We did testing with several bow types and they all seemed to display the same completely chaotic numbers. The same was also done with weapons, though 2-handed weapons seemed to put out more consistantly high numbers (2-handers are gonna be nasty powerful come the combat revamp, just watch). I would agree that the AR boosts from the different types would increase overall DPS though.
A lot of the stuff on that list is totally akin to what was told to us during all of the peddles though, that's for sure. Persaruim on this list is listed as being the best weapon material as well as the best armor, and I am certain that when one of the persaruim weapons out there were sold, it was specifically stated to everyone that it wasn't as good as electrum. Same goes for blacksteel vs arcsilver, which was always told to us as being equal in protection values.
@Kschilan's player: No problem. I'm probably considered the mechanics nazi around here, lol. I don't really know why it interests me so much. I guess I just like knowing how stuff works. Anyways,
your suspicions are correct! The combat update is supposed to fix the crazy damage variations that we see now. Melee and bow users are going to have a really nice and much needed boost to their damage. Beast races are gonna be ridiculous, rofl.